B C E Flute Corrugated Board Prodcuion Line For Two Layer
Corrugating Paper
1.Main Features for Single facer corrugated board Production Line
1. Cover vacuum suction.
2. Corrugating roll is made of high quality alloy steel 48CrMo, the
surface is medium-frequency quenched and chrome-plated. Hardness
can reach HRC55~60, which ensures good wear-resistance and long
life service.
3. No gear transmission.
4. Glue roll is lifted and lowered pneumatically.
5. Independent glue clean device and electric glue-separate board
to control the width of glue.
6. Manually regulate or electrically regulate the display device.
7. Lubricated by high temperature lubricate grease.
8. Surface of all dancing rolls and preheating rolls is grinded and
chrome-plated.
9. Pressure roll is medium- frequency quenched and chrome-plated.
10. Width 1400mm~2000mm.
11. Preheating rolls, pressure rolls and corrugating rolls all meet
the National Standard of Pressure Vessel. Working pressure is
1.1MPa.
2. What is the Single facer corrugated board production line used
for ?
Single Facer is the main machine for producing the corrugated
paperboard. make single face corrugated board from flat craft paper Vacuum suction model single facer has very good production
precision. The choose of the machine is directly effecting the
quality of the corrugated paperboard.
Note : This machine can also make 3 layer 5 layer 7 layer when work
together with gluing machine and pressing machine
3.What is the main structure for Single facer group and working
principle ?
This line including paper mill roll stand and single facer machine
Step one : Make craft paper to mill roll stand
Step two :Heat the corrugated layer by heating shaft
Step three :Make the flat paperboard to corrugated board by
corrugated shaft
Step Four : Gluing top wave by glue shaft and make this two pieces
paper to monolayer corrugated board
4.SIngle facer corrugated board production line specification
| General Parameter | 1) Design Speed :100m/min 2)Design Width :2000mm 3)Temperature scope:160-200oc 4)Pressure of compressed air supply :0.4-0.9mpa 5)Pressure of steam :0.8-1.3Mpa 6)Corrugating type :UV or UVV |
| Diameter of rollers | 1) Corrugating roller :280mm 2)Pressure roller :284mm 3)Gluing roller :215mm 4)Pre-heater roller :320mm |
| Electrical Parameters of motors | 1)Main drive motor :7.5KW 2)Air suction motor :7.5KW 3)Glue reducer motor :100W 4)Gluing roller gap adjusting motor :250W 5)Glue pump motor :2.2KW |
5.Finished corrugated paper made by Single facer corrguated board
production line
6.Whole machine view
